HOW TO INSTALL MESH STAIR RAILING/ CONTINUED TREX SELECT ®
Install Mesh Caps
16
minus 7/8"
18
minus 7/8"
16. R emove mesh panel. Substract 7/8" from top of mesh, and only ONE SIDE of mesh and mark these locations. Cut at all marked lines. NOTE: An angle grinder (with proper blade) is recommended for cutting wire mesh. (ALWAYS USE PROPER SAFETY GEAR WHEN CUTTING WITH ANGLE GRINDER.) Note that heavy duty bolt cutters can also be used.
18. Install mesh caps on all cut ends.
Install Anti-Rattle Gaskets onto Mesh
19
Intalling Top Channel
17
6' Section = Minimum 4 screws 8' Section = Minimum 5 screws
17. Remove top rail, and center top channel between slots in brackets and centering on rail (NOTE: There may be a slight gap on each end between brackets and channel), and install using #8-18 x 1 1/4" self-drilling screws (C3).
19. .Install top and bottom gaskets onto mesh panel, followed by side gaskets. Make sure all gaskets are centered and fully seated.
7
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
SMST-0726
Made with FlippingBook flipbook maker