GWO Basic Technical Training V6.0
2021-04-01_TS_BTT_V06
b. Rubber and PVC insulation types
c. Install heat/cold shrink tube on top of cable and cable lug after cable lug has been crimped.
a. Copper and aluminium (special attention to the correct cable die-set)
b. Rubber and PVC insulation types.
The instructor shall:
ELEMENT 9.7 - MARKING, ROUTING AND TERMINATION OF ALL CABLE TYPES
Learning objectives:
The participants can describe typical faults during termination, and ways to mitigate these typical faults (Knowledge, basic level) The participants can perform the marking, routing and termination of all cable types (Skills, intermediate level)
The instructor shall:
a. Cable and conductor
b. Cabinet (diagram)
a. Bending radius (why a minimum is important)
b. Not twisted
c. Distance between cables types and groups
d. Fastening of cables: fixed vs flexible
e. Cable protection tubes or edge protection
f.
Cable glands.
a. Handle with care due to fragility (lower it individually, do not combine with other cables when handling)
b. Excess cable should not be cut out, but coiled
Global Wind Organisation www.globalwindsafety.org
137 / 158
Made with FlippingBook - professional solution for displaying marketing and sales documents online