Section 6
Recipe Settings
Flash Temperature – Desired booth temperature during flash mode. Some coatings require a period of time after being applied to “flash off”. During this time, the temperature is lower than a high heat cure temperature.
Flash Time – Amount of time the coating needs to flash off. See the spec sheet for the coating being used.
Cure 1 Temperature – Desired booth temperature during cure mode 1. See the spec sheet for the coating being used.
Cure 1 Time – Amount of time the coating needs to cure.
Cure 2 Temperature – Desired booth temperature during cure mode 2. See the spec sheet for the coating being used.
Cure 2 Time – Amount of time the coating needs to cure. (Set to zero if cure 2 is not needed)
Cool Temperature – Desired booth temperature after the cure mode has finished. Cool Time – Amount of time the coating needs to cool.
Everything above is 1 recipe. The controller is capable of storing 4 recipes labeled A, B, C, and D
Made with FlippingBook - professional solution for displaying marketing and sales documents online