Uncheck to disable the use of the Destination MAC Address (This is the default.) IP Address The IP address can be used to calculate the destination port for the frame. By default, IP Address is enabled.
Check to enable the use of the IP Address (This is the default.)
Uncheck to disable the use of the IP Address
TCP/UDP Port Number The TCP/UDP port number can be used to calculate the destination port for the frame. By default, TCP/UDP Port Number is enabled.
Check to enable the use of the TCP/UDP Port Number (This is the default.)
Uncheck to disable the use of the TCP/UDP Port Number
4.25.2
Aggregation Group Configuration This section allows the user to configure aggregation groups.
Group ID Set or show the group ID for the settings contained in the same row. Group ID “Normal” indicates there is no aggregation. Only one group ID is valid per port. Port Members Each switch port is listed for each group ID. Select a radio button to include a port in an aggregation, or clear the radio button to remove the port from the aggregation. By default, no ports belong to any aggregation group. Only full duplex ports can join an aggregation and ports must be in the same speed in each group.
4.25.3
Aggregation Configuration Buttons Save: Click to save all changes Reset:
Click to undo any changes made locally and revert to previously saved values
4.26
Aggregation – LACP
LACP is an IEEE 802.3ad standard protocol. The Link Aggregation Control Protocol, allows bundling several physical ports together to form a single logical port.
SMB - CLI UM
Rev: 1.1
Page 138 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator