2.1.4
Ethernet Interface Reference In the RES-SCE-8MG, the Ethernet interface (“port”) is referenced in the following manner: * means all ports of all types on all switches GigabitEthernet: defines the Ethernet type (1 Gigabit Ethernet Port), which requires a follow-up parameter (< port_type_list> in the sample below) that specifies the switch and the port number(s) on the switch (for example: 1/8 indicates port 8 on switch 1 or 3/1,3,5-7 indicates ports 1, 3, 5, 6, and 7 on switch 3) Sample Syntax: clear dot1x statistics [ interface ( <port_type> [ < port_type_list> ] ) ]
2.1.5
CLI Command Description The following sections will describe each command as follows:
List the individual command
Give a brief description of the action triggered by the command
Show the syntax of the command, and list the legal values and meanings of the parameters
2.2
Clear Commands
Use the clear commands to reset functions. The following functions can be reset (cleared): Access Access management Access-list Access list Dot1x IEEE Standard for port-based Network Access Control IP Interface Internet Protocol config commands LACP Clear LACP statistics LLDP Clears LLDP statistics. Logging Syslog MAC MAC Address Table Spanning-Tree STP Bridge Statistics Clear statistics for one or more given interfaces
2.2.1
Clear Access Clear Access Management statistics. Syntax: clear access management statistics Clear Access-List Clear Access-List Entry (ACE) traffic statistics. Syntax:
2.2.2
SMB - CLI UM
Rev: 1.1
Page 14 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator