Trex® Lighting Installation Overview

TREX® LIGHTING–SPLITTERS AND WIRING INSTALLATION

» ALWAYS INSTALL WIRING AND SPLITTERS BEFORE DECKING AND RAILING HAVE BEEN INSTALLED. » USE A SINGLE MALE CONNECTION ON SPLITTER TO CONNECT TO TRANSFORMER.

Post Caps

Decking Structure

6" (152 mm)

Attach wire to post with female connection at top of post and male connection at bottom to connect to splitter. Avoid running wire on side of posts where railing brackets or under-rail lights are to be installed. Leave approximately 6" of lead at top of wire to make connections with post cap.

Install splitters to inside of framing using hardware provided. Install at every post base where lighting is present and depending on spacing in between each type of light being used.

Oval Riser

Decking Structure

Oval Riser lights should be spaced 20” or less apart. If wider, an extension cable will be required. Ensure that splitters are installed within reach of first oval light or use wiring extensions when necessary.

Linear Riser Lights

Wiring must be run under decking structure, behind stringers and/or risers. Example shown here. Mount splitter high enough to ensure some slack in under-rail light wire.

Make sure splitter is within 6” of first linear riser light. Ensure stair riser has overhang of 3/4” to allow for proper installation of linear riser light.

6

LIGHT-OVERVIEW-1026

Made with FlippingBook Annual report maker