TREX® LIGHTING–MAKING CONNECTIONS
First Splitter From Power Source
Oval Riser Lights Installation » Install riser lights after stairs and risers have been installed. » Avoid locations over stringers as holes are difficult to create.
1
Power in
Light connection
1
4" (102 mm)
Power out to next splitter
1. Attach male lead from lights to female (out) connections on splitter. Also attach connection wiring in between each splitter. Continue until all wiring from lighting and connector wires are attached between splitters.
1. Mark locations for each light, generally 4" above tread. Consult local codes for lighting requirements.
2
2
2. Drill a 1" diameter hole using Forstner bit, at least 1” deep into riser (if riser is thicker than 1", use a 1/2" drill bit to create a passage for wires).
2. Cap off all unused connections on splitters with caps provided.
3
3. Thread wires through hole. Press light into hole, ensuring lens in fully seated and oval light is in correct orientation. Make connections behind stairs from lead wire on oval light to female connection on splitter. Cap off any connections not being used. When daisy chaining oval riser lights, plug long female lead into short male lead.
7
LIGHT-OVERVIEW-1026
Made with FlippingBook Annual report maker