TREX SELECT ® ALUMINUM RAILING PANEL Stair Installation Instructions
KEY Mark Cut
KEY
4
6
1/16"
4. C enter stair brackets on posts below the marked line and attach using four #10 x 3/4" self-drilling screws (provided). In some cases it may be difficult to attach the stair bracket on the lower stair post. A 90˚drill or adapter is recommended to attach screws in this area.
6. R emove panel and place on flat surface (note stair panel can be "unracked" if necessary for ease of cutting - use caution as balusters may come lose). Extend marks to side of rails. Brackets are designed to allow for railing to be installed with a standard perpendicular cut. Cut end of rails 1/16" shorter than mark on each side to allow for a better fit.
Marking and Cutting Stair Panel Rails (when required)
5
Installing Foot Block Insert
7
5. M ark top and bottom rails where they align with the rear wall of the top and bottom brackets.
7. Turn panel upside down.
2
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
SEALST-0826
Made with FlippingBook Digital Proposal Creator