Trex Select® Aluminum Railing Installation Instructions

TREX SELECT ® ALUMINUM RAILING PANEL Stair Installation Instructions

IMPORTANT–IF INSTALLING TREX LIGHTING, SCAN QR CODE TO OBTAIN RAILING & LIGHTING INSTRUCTIONS / DO NOT USE INSTRUCTIONS BELOW. FAILURE TO DO THIS WILL RESULT IN IMPROPER RAILING AND LIGHTING INSTALLATION!

SCAN QR CODE IF INSTALLING COCKTAIL RAIL APPLICATIONS WITH TREX METAL RAILING SYSTEMS.

NOTES: » FOR A 6' OR 8' STAIR RAIL, POST TO POST SPAN WILL BE LESS THAN 6' OR 8'. PRIOR TO INSTALLING STAIR POSTS CALCULATE POST TO POST SPAN USING A MAXIMUM STAIR RAIL LENGTH REQUIRED AND THE ANGLE AT WHICH THE STAIR RAILS WILL BE INSTALLED. DO NOT INSTALL STAIR POSTS AT 6' OR 8' SPAN, AS STAIR RAILINGS WILL THEN BE TOO SHORT. » FOR STAIR INSTALLATIONS USE A 53" STAIR POST. POST CAN BE CUT TO DESIRED HEIGHT ONCE RAILING HEIGHT IS ESTABLISHED. ENSURE ADEQUATE SPACE FOR POST CAP TO FIT PROPERLY. » DO NOT CUT SELECT ALUMINUM RAILING PANELS ON TOP OF DECK SURFACE. METAL FLAKING CAN BE DIFFICULT TO CLEAN. » ALWAYS WEAR APPROPRIATE SAFETY GLASSES WHEN CUTTING METAL. »  USE CAUTION WHEN INSTALLING STAIR PANEL AS TOO MUCH RACKING MAY CAUSE PANEL TO DISENGAGE. »  ENSURE BARREL BOLTS ON SWIVEL BRACKETS ARE TIGHT DURING AND AFTER RAILING INSTALLATION. »  SELECT ALUMINUM STAIR RAIL PANELS REQUIRE A SINGLE FOOT BLOCK FOR ANY SPAN LENGTHS.

TOOLS NEEDED

7/64" (2.8 mm)

1

Attaching Upper and Lower Stair Swivel Brackets

1. Install post close to nose of stair tread directly above the required blocking. ALWAYS refer to your local building code official prior to installing any railing

3

system to ensure all code and safety requirements are met. Trex cannot be held responsible for improper or non-recommended installations.

2

3. A lign the bracket with top and bottom railing. Mark a light line on post above the swivel base.

2. U se a 1" deck board as a spacer board and lay this on the stair treads between the posts. Place stair panel on top of the deck board and clamp stair panel to posts. Ensure that balusters are straight and positioned with equal spacing at post locations. Make a small mark near the center of the panel for the location of the foot block.

1

Have Questions? 1–800–BUY–TREX

NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com

SEALST-0826

Made with FlippingBook Digital Proposal Creator