Trex Select® Aluminum Railing Installation Instructions

TREX SELECT ® ALUMINUM RAILING Horizontal Installation Instructions

HOW TO INSTALL SELECT ALUMINUM RAIL HORIZONTAL PANEL/ CONTINUED

Attaching Brackets if using Pressure-Treated Posts with 6 x 6 Post Sleeves

How to Measure and Cut Panel Rails (When REQUIRED)

1

1

Install One-Piece Skirt and Post Sleeve 1. Slide one-piece skirt down to rest on decking surface. Slide post sleeve over post and position inside post sleeve skirt.

2

3

1. Position panel between posts and ensure there is equal distance on each of the end balusters and posts. Allow 1-1/2" on each side of rails to allow for attachment to brackets.

33-1/4" (84.5 cm) or 39-1/4" (99.7 cm)

2" (5.1 cm)

KEY Mark Cut

KEY

2

2. Measure up from top of skirt 2". Mark with light line. 3. M easure up from top of skirt 33-1/4" for 36" rail height or 39-1/4" for 42" rail height. Mark with light line.

5

4

3/8"

3/8"

2. Cut ends of both bottom and top rails 3/8" shorter on each side to allow for fit into brackets.

4. Center lower bracket on post above the marked line and attach using two #10 X 1-3/4" stainless steel screws (included). 5. Center upper bracket on post above marked line and attach using four #10 X 1-3/4" stainless steel screws (included).

Installing Foot Block

3

3. Turn panel upside down.

4

Have Questions? 1–800–BUY–TREX

NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com

SEALHZ-0826

Made with FlippingBook Digital Proposal Creator