CONTURO Edge Bander booklet

Routing and smoothing edges flush, trimming overhanging material




First trim the overhang from the edging using the MFK 700 so that it is flush with the panel. Practical: the extractor hose is attached directly at the tabletop and does not pose an obstacle when guiding the machine. The ball bearing guide brake ensures perfect, streak-free working results.



To achieve a clean, rounded finish, move the edge router towards the edging with the cutter rotating and trim the overhang as well as the radius.

You can remove any remaining overhang using the scraper.


NOTE Special classic ogee cutters with reversible blades are available for the MFK 700 Basic with radii of 1, 1.5, 2 and 3 mm. Suitable for edging thicknesses of 1, 1.5, 2 and 3 mm.

If the cutter leaves impact marks during the routing process, you can smooth them over using the scraper.


Made with FlippingBook - Online catalogs