Article Multilayer Barrier Coatings with Starch/Bentonite for Paperboard—The Effects of the Number of Layers and the Drying Strategy on the Barrier Properties Lars Järnström 1, * ,† , Hanna Christophliemk 1,‡ , Erik Bohlin 1,§ , Johan Larsson 2 and Per Emilsson 3
1 Department of Engineering and Chemical Sciences, Karlstad University, 651 88 Karlstad, Sweden; hanna.christophliemk@vtt.fi (H.C.); erik.bohlin@billerud.com (E.B.) 2 Billerud Skog & Industri AB, 801 81 Gävle, Sweden; johan.a.larsson@billerud.com 3 UMV Coating Systems AB, 661 32 Säffle, Sweden; per.emilsson@umv.com * Correspondence: lars.jarnstrom@kau.se; Tel.: +46-738-443-033 † Current address: Lars Järnström Consulting, 756 44 Uppsala, Sweden. ‡ Current address: VTT, 02150 Espoo, Finland. § Current address; Billerud AB, 664 33 Grums, Sweden. Abstract This study investigates the impact of multilayer structures and drying strategies on the barrier properties of high-speed starch/bentonite-coated paperboard. The study examines the impact of drying at a high machine speed of 400 m min − 1 , addressing a key knowledge gap. The hypotheses were that thin multilayer coatings reduce oxygen permeability more effectively than thick single or double coatings and that gentle infrared (IR) drying would be required to achieve this effect. The experiments comprised up to six consecutive coating applications, each providing a dry coat weight between 0.5 and 1.5 g m − 2 . The IR dryer power ranged from 207 kW to 829 kW, and different IR frame positions were tested. The results indicated that thin multilayer coatings resulted in fewer pinholes, lower oxygen transmission rates, and improved grease resistance compared with one or two thick layers. However, the effectiveness of the multilayer-coated paperboard was influenced by the employed drying strategy. Specifically, gentle IR drying reduced pinholes, lowered oxygen transmission rates and enhanced grease resistance.
Keywords: paper coating; barrier coating; drying; multilayer coating; paperboard; starch; bentonite; topographic analysis
1. Introduction Substantial efforts have been made to increase the use of paper-based packaging mate- rials as replacement for fossil-based alternatives, as a part of a transition toward sustainable raw materials. Packaging materials that provide oxygen, moisture vapour, water, oil and grease barriers are critical in packaging applications such as food packaging [1,2]. Modified atmosphere packaging (MAP) is used to extend the shelf life of food products such as meat, fruit and vegetables. For meat, adequate carbon dioxide partial pressure in the headspace is needed to inhibit the growth of microbial organisms. In such cases, the packaging must prevent the loss of carbon dioxide [3]. For fresh fruits and vegetables, which undergo respiration and transpiration, careful control of the passage of water vapour, oxygen and carbon dioxide through the packaging material is needed to optimise the shelf life [4,5]. The present study focuses on oxygen and grease barrier performances.
Academic Editor: Federico Barrino
Received: 30 January 2026 Revised: 20 February 2026 Accepted: 25 February 2026 Published: 28 February 2026
Copyright: © 2026 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license.
Coatings 2026 , 16 , 299
https://doi.org/10.3390/coatings16030299
Made with FlippingBook Online newsletter maker