PAPER making! FROM THE PUBLISHERS OF PAPER TECHNOLOGY INTERNATIONAL ® Volume 12, Number 2, 2026
H12 to H20. SEM analysis confirmed that H20 possessed a uniform interfacial adhesion between the starch – CNF matrix and hemp fibers, while both excessive (H28) and insufficient (H12, 12g hemp hurds) fiber loadings resulted in structural irregularities. These findings demonstrate a value-added upcycling strategy that converts underutilized hemp byproducts into high-performance molded fiber packaging materials composed entirely of bio-derived constituents. “ 3D printing to optimize the dry forming of thermomechanical pulp and chemi- thermomechanical pulp trays for food packaging ” , Gary Chinga-Carrasco, Sustainable Materials and Technologies , Vol.48, 15 July 2026, e01928. Environmental concerns over plastic pollution have intensified the search for alternative materials for single- use products, such as trays for food packaging. Dry forming, using wood pulp fibres, is a promising technology for the fabrication of various single-use products. However, the fabrication of trays with relatively complex geometry is challenging. In this study, an approach is introduced where trays are pre-formed in tailored three-dimensional (3D) printed meshes with varying distances between the printed lines in the side walls (1.5mm, 1.8mm and 2.0mm) and bottom (1.0mm) of the trays. This was expected to facilitate the deposition of wood pulp fibres during formation of a given tray geometry and subsequently yield trays with adequate grammage and mechanical properties. The approach was tested with thermomechanical pulp (TMP) and chemi-thermomechanical pulp fibres (CTMP). Both fibres have similar chemical composition (carbohydrates and lignin), but differed with respect to the structural properties. TMP fibres revealed higher fraction of disrupted fibres and fibrils on the fibre surfaces. These characteristics increased the densification of the TMP trays during thermoforming and thus provided higher mechanical properties, compared with the corresponding CTMP trays. A tray demonstrator was developed, with tray depth of 50mm and side wall angles of 65°. Thermopressed trays (pressure and temperature of 40MPa and 200°C, respectively) yielded strength and modulus of 1 – 10MPa and 400 – 1600MPa, respectively. The mechanical performance depended on the type of fibre (TMP or CTMP) and on the area of measurement in the trays (side walls or bottom). NANOSCIENCE “ A Review on Current Progress of Nano Additives in Pulp and Paper: Processing, Characterization and Applications ” , Mohamad Nurul Azman Mohammad Taib, Areisman Salleh & Zayd C. Leseman, Journal of Natural Fibers , Vol.23, No.1. The pulp and paper products have issues regarding their physical, mechanical, and barrier properties during processes and prolonged storage before being utilized by consumers. Nano additives are an alternative compared to micro-sized commercial additives used in industry because of their high aspect ratio and available surface area to be bonded with pulp and paper products. The incorporation of nano additives such as nanocellulose, nano-clays, carbon- based nanomaterials, and metal oxide nanoparticles offers tremendous potential to enhance mechanical strength, barrier performance, antimicrobial and other functional properties of paper products while reducing reliance on chemical additives. This review provides a comprehensive overview of the recent progress in the utilization of nano additives in pulp and papermaking, covering processing methods, surface functionalization strategies, integration approaches, and their influence on paper performance. Special attention is given to the interaction between nano additives and fiber matrices, dispersion challenges, and scalable processing techniques. The manuscript also highlights current limitations in nano additives application, including compatibility with industrial systems, cost-effectiveness, and environmental impact. Finally, future recommendations and industrial implementation opportunities are discussed, positioning nanofillers as a pivotal component in the advancement of next-generation paper-based materials.
Page 7 of 13
Technical Abstracts
Made with FlippingBook Online newsletter maker