PAPERmaking! Vol12 Nr2 2026

Coatings 2026 , 16 , 299

21of 25

of the IR power resulted in blistering, most likely as a consequence of premature film formation. • Modifying the placement of the IR frames to be solely on the coated side of the paperboard appeared to mitigate pinholes and reduce oxygen penetration. • Thin multilayer coatings exhibit fewer pinholes, lower oxygen transmission rates and enhanced grease resistance compared to one or two thick layers, suggesting that multilayer technology might potentially contribute to material savings and promote resource-efficient production. • A significant reduction in pinholes and oxygen transmission was noted for the multilayer-coated samples after the application of two thin layers. • A contour coating was achieved for both the multilayer-coated paperboard and the thick single- and double-coated reference samples. • Significant compression of the substrate beneath the blade was required to obtain the observed contour coating for the multilayer-coated paperboard. Although not directly examined in the present study, it is conceivable that the compliance of the metering tip also contributed to the resulting coating uniformity. • In comparison to thick single or double coatings, the multilayer technique produced a smoother surface when measured over several fibre diameters. • The bentonite–starch–PEG formulation demonstrated limited suitability for packaging oxygen-sensitive foods but showed potential for other packaging applications or as a precoating layer. Further work should explore improved substrates, top-coats and durability tests to advance towards commercial application. Author Contributions: Conceptualisation, L.J. and P.E.; methodology, L.J., H.C., E.B., J.L. and P.E.; formal analysis, L.J. and H.C.; investigation, L.J., H.C., E.B., J.L. and P.E.; resources, L.J., J.L. and P.E.; writing—original draft preparation, L.J. and H.C.; writing—review and editing, L.J., H.C., E.B., J.L. and P.E.; supervision, L.J.; project administration, L.J. and P.E.; funding acquisition, L.J. and P.E. All authors have read and agreed to the published version of the manuscript. Funding: This research was funded by the SWEDISH GOVERMENTAL AGENCY FOR INNOVA- TION SYSTEMS (VINNOVA), file reference number 2014-00319; STIFTELSEN NILS OCH DORTHI TROËDSSONS FORSKNINGSFOND, Sweden, grant application number 866/15; and the KNOWL- EDGE FOUNDATION, Sweden, file reference number 20180036. Institutional Review Board Statement: Not applicable. Informed Consent Statement: Data are contained within the article. Data Availability Statement: The original contributions presented in this study are included in the article. Further inquiries can be directed to the corresponding author. Conflicts of Interest: Lars Järnström (L.J.) runs the sole proprietorship Lars Järnström Consulting, and Hanna Christophliemk (H.C.) is employed by the research organisation VTT. L.J. and H.C. declare no conflicts of interest. Erik Bohlin (E.B.), Johan Larsson (J.L.), and Per Emilsson (P.E.) hereby disclose their conflict of interest as outlined by the MDPI guide. E.B. and J.L. work for Billerud Skog & Industri AB and Billerud AB, respectively. Billerud, a pulp and paper company, manufactures coated paperboards among other products. P.E. is an employee of UMV Coating Systems AB, a company that manufactures coating equipment. The present study discusses fundamental issues relevant to most pulp and paper companies. The results are presented impartially, and the research was conducted in the absence of any commercial or financial compensation.

https://doi.org/10.3390/coatings16030299

Made with FlippingBook Online newsletter maker