PAPERmaking! Vol12 Nr2 2026

4

J Renew Mater. 2025

0.8 gNaH 2 PO 4 , 0.4 gK 2 HPO 4 , and 0.5 g MgSO 4 , adjusted to pH 6. All reagents were sourced from Sigma- Aldrich (Schneldorf, Germany). Cultivation proceeded in a Multitron incubator shaker (Infors HT, Basel, Switzerland) at 27 ○ C and 150 rpm for 14 days. 2.4 Incubation Following cultivation, mycelial pellets were homogenized using a Waring laboratory blender (Waring Commercial, Torrington, CT, USA) and evenly mixed with sterile substrates in 4 L filter patch bags. Incubation of the inoculated bags was carried out in the dark at 20 ± 2 ○ C and 70 ± 5% RH for 14 days (Fig. 1). Subsequently, the mycelium-substrate mixture was transferred into molds (200 mm × 200mm × 40 mm) for a second growth phase under the same environmental conditions for an additional 7 days. Upon completion, the EPW biocomposites were removed from the molds followed by drying at 70 ○ C for 24 h to terminate fungal growth and assess moisture content. Moisture content (%) was calculated based on the weight difference between wet and dry samples. The dried panels were then sectioned into different specimen sizes with a bandsaw for further testing.

Figure 1: Development stages of EPW mycelium biocomposites: ( A ) initial cultivation in filter patch bags; ( B ) secondary growth in molds; ( C ) final biocomposite panels 2.5 Mechanical Properties Each specimen was weighed and its length, width, and thickness measured with a digital caliper. Volume and density were subsequently calculated using Eqs. (1) and (2):

l × w × h 1000

V =

,

(1)

where V is volume (cm 3 ), l is length (mm), w is width (mm), and h is height (mm). ρ = m V ,

(2)

where ρ is density (g ⋅ cm − 3 ), m is mass (g), and V is volume (cm 3 ). Compression tests were conducted on five parallel specimens measuring 30 mm × 30mm × 30mm using a Zwick/Roell Z010 (ZwickRoell, Ulm, Germany) universal testing machine. The procedure followed a modified ISO 844:2021 [35] standard under controlled laboratory conditions of 23 ○ C and 50% RH. The mechanical load at 10% relative deformation of the specimen was determined. The compression speed corresponded to 10% def/min, and the preload was 2 N. During the test, a force-displacement graph was recorded, from which the compressive modulus of elasticity (E) was determined by drawing a tangent to the steepest part of the curve. Both the compressive strength at 10% deformation ( σ 1 0 ) and E were calculated automatically by the software.

Made with FlippingBook Online newsletter maker