HOW TO INSTALL TRADITIONAL MESH STAIR RAILING TREX SIGNATURE ®
6
5
5. P lace 2 x 4 on top stair rail. 6. S ecure 2 x 4 to top rail using Trex Signature Cocktail Bracket (sold separately). Ensure that there is a bracket at each end of the railing section, then space brackets approximately every 24" and attach with 4 screws pro- vided.
IMPORTANT NOTES: » O nly for use with pressure-treated 4 x 4 post (3.5" nominal square) and 4" x 4" (102 mm x 102 mm) or 6" x 6" post sleeves, Trex Post Mounts or Trex Joist Mount Post WITH Trex post sleeves. Signature Joist Mount Posts cannot be used with Trex Signature Traditional railing. 1. Installing Pressure-treated Posts, Post Sleeves, and Skirts See instructions on page 2. 2. Installing Brackets Follow previous stair instructions for the installation of desired brackets, making sure that all dimensions are calculated before installation, and ensuring deck board is placed in correct location. 3 F ollow all Stair Mesh instructions for the assembly of the stair mesh panel Attaching 2 x 4 to Top Rail
NOTE: Pre-drilling before attachment is recommended.
7. P re-drill a pilot hole and toenail 2-1/2" (6.4 cm) screw at each end of 2 x 4 into post on back side of rail (side not facing decking). NOTE: Top Bracket Covers are not attached in this configuration.
7
4
4. P lace 2 x 4 beside top rail. Mark and cut (both ends need to be cut on an angle for proper fit).
15
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
TSMSR-0125
Made with FlippingBook Digital Publishing Software