Technical training
Service Lift Training Standard / V4
9. SERVICE LIFT INSTALLATION, INSPECTION AND REPAIR MODULE 9.1 Aims of the Service Lift Installation, Inspection and Repair Module The aim of this module is to enable the lift technician to: install and ensure the readiness of the lift and the lift plant by inspecting and maintaining; to take correct measures to acquire assistance; and repair and replace components in a lift in a WTG accordance with relevant manuals and legislation. These inspections cover both initial inspections for the purpose of commissioning the lift, general required inspections, and inspections after replacement of main components.
Fundamental for the training is the wind technician’s attention to, and awareness of, always following and seeking guidance from the relevant lift manuals and instructions.
The overall learning objective of this module is:
1) The participants can solve routine tasks in relation to the commissioning, inspection, installation, and maintenance of lifts in a WTG following guides and manuals (Ability, basic level).
9.2 Course Participants’ Prerequisites for the Service Lift Installation, Inspection and Repair Module GWO Service Lift User Module training or similar brand specific user training is a prerequisite to participate in the Service Lift Installation, Inspection and Repair Module training.
Basic technical experience and knowledge, primarily mechanical and electrical, is necessary to be able to get full benefit from the training.
9.3 SLIIR Module Instructor´s Qualification
As an addition to the GWO Requirements for Training, a competent SLIIR Module instructor must be approved as such by a competent instructor or train-the-trainer.
A competent instructor or train-the-trainer must hold the sufficient lift technical experience on multiple lift types obtained by, for example, work experience, lift trainings and manufacturer led lift trainings
Note
The purpose of this is to ensure the necessary technical understanding of lift functionalities and that this is not lift brand specific.
9.4 Duration of the Service Lift Installation, Inspection and Repair Module
The total contact time for completing the Service Lift Installation, Inspection and Repair Training Module is 14 hours and 0 minutes.
The training provider must not exceed the times per day given in table 9.4.1 below.
Global Wind Organisation ©2024 / www.globalwindsafety.org
104 / 166
Made with FlippingBook flipbook maker