Technical training
Lift Standard / V3 2023-05-02
Present and demonstrate examples of how to do a visual inspection of all bolts and bolt connections for completeness and tightness the upper and lower attack pinion
Lead or facilitate a discussion on bolts and bolt connections and their completeness and tightness
The participants shall:
Engage in discussions and share experiences on bolt and bolt connections on the upper and lower attack pinion and their completeness and tightness
Conduct a short questionnaire test to recap the theory and safety issues from Lesson 11
Check own answers and solutions from the shown fact list on completion of the test
DRIVE AND SAFETY WIRE ROPE AND RACK
140 min.
The aim of this lesson is to enable the participants to test and ensure the functionality of drive and safety ropes and racks in accordance with the relevant manuals and inspection lists. After successfully having completed Lesson 12 of the Lift Commission, Inspection, Installation and Maintenance Module: 109) The participants can take responsibility to do a visual inspection and replacement of drive and safety ropes according to ISO 4309 (Ability, intermediate level)
ELEMENT 12.1 - DRIVE ROPES, IN GENERAL
Learning objectives:
110) The participants can perform a replacement of drive and safety ropes according to ISO 4309 (Skills, intermediate level) 111) The participants can perform a visual inspection of the diameter of drive rope and safety rope in unloaded state at three points: bottom, middle and top (Skills, intermediate level) 112) The participants can explain how to do correct greasing of the drive rope sufficiently according to the relevant manual (Knowledge, intermediate level)
Global Wind Organisation©2023 / www.globalwindsafety.org
129 / 171
Made with FlippingBook flipbook maker