Technical training
Service Lift Training Standard / V5 02052025
Engage in discussion about how and when to test the system that monitors the condition of the primary suspension cable by following procedures according to the relevant manual (e.g. monitoring sensors and slack-rope test)
Engage in practice about visual inspection of the diameter of drive rope and safety rope in unloaded state at three points: bottom, middle and top
Engage in practice how to do correct greasing of a drive rope sufficiently according to the manual
Share experiences, and apply the received feedback in following exercises
ELEMENT 12.2 - TENSION WEIGHTS
Learning objective:
69) The participants can perform inspection, installation, and adjustment of tension weights installations, in accordance with the manuals (Skills, intermediate level)
The instructor shall:
Demonstrate how to inspect, install and adjust tension weights according to manuals and instructions
Facilitate practical training on inspecting and adjusting tension weights
Provide feedback to the participants on their performance during the practical training
The participants shall:
Practise how to inspect and adjust tension weights to have free space above (full loaded lift) or below (unloaded lift) in distances given in accordance with the manuals
Engage in the discussion about how to install tension weights on different lift types
Apply the received feedback in following exercises
ELEMENT 12.3 - GROUNDING ROTATING UNIT
Learning objective:
Global Wind Organisation ©2025 / www.globalwindsafety.org
139 / 170
Made with FlippingBook flipbook maker