Technical training
Service Lift Training Standard / V5 02052025
Engage in the exercise on inspecting labels and type plates, take part in discussions and share experiences on how and what to inspect in relation to labels and type plates on FADs and how to apply labels
ELEMENT 15.2 - GENERAL CONDITION
Learning objective:
91) The participants can perform an inspection of the general condition of a fall arrest device, and replace a fall arrest device, following the manuals (Skills, intermediate level)
The instructor shall:
Present key points in relation to the inspection of the general condition of fall arrest devices in different lift types, e.g.:
a.
Wear on intake bushing
b.
The electrical wiring from the FAD
c.
Centrifugal system
Demonstrate how to install different types of fall arrest devices by following manuals
Facilitate an exercise, where the participants investigate manuals and discuss how to inspect and replace different types of fall arrest devices
Lead a discussion about how and why components in fall arrest devices are tested in accordance with the manufacturers’ manual
Lead or facilitate a discussion on differences between different fall arrest devices in different lift types
The participants shall:
Engage in the practical training, reflect on the received feedback, and take active part in discussions and share experiences from working with fall arrest devices
SUPPLY CABLE
20 min.
Global Wind Organisation ©2025 / www.globalwindsafety.org
151 / 170
Made with FlippingBook flipbook maker