Technical training
Lift Standard / V3 2023-05-02
8. LIFT COMMISSION AND INSPECTION MODULE 8.1 Aims of the Lift Commission and Inspection (LCI) Module
The aim of this module is to enable the lift technician to inspect the lift after installation in a WTG with the purpose of commissioning; to take correct measures to acquire assistance; and perform simple adjustments or replacement of parts in a lift in a WTG. Fundamental for the training is the wind technician’s attention to, and awareness of, always following and seeking guidance from the relevant lift manuals and instructions.
The overall learning objective of this module is:
95) The participants can solve routine tasks in relation to the commissioning and inspection of lifts in a WTG following relevant guides and manuals (Ability, basic level).
8.2 Course Participants Prerequisites for the Lift Commission and Inspection Module GWO Lift User training or similar brand specific user training is a prerequisite to participate in the Lift Commission and Inspection Module training. Basic technical experience and knowledge (primarily mechanical and electrical) is necessary to be able to get full benefit from the training. 8.3 LCI Module Instructor’s Qualification As an addition to GWOs Requirements for Training, a competent LCI module instructor must be certified as such by a competent instructor or train-the-trainer.
A competent instructor or train-the-trainer must hold the sufficient lift technical experience on multiple lift types obtained by (for example) work experience, lift trainings and manufacturer led lift trainings.
Note
8.4 Duration of the Lift Commission and Inspection Module The total contact time for completing the Lift Commission and Inspection Training Module is 7 hours and 0 minutes.
The training provider must not exceed the times per day given in table 8.4.1 below.
Maximum Duration Per Day
Contact time
8 hours
Total training day
12 hours
Table 8.4.1 – Maximum durations for training day
Global Wind Organisation©2023 / www.globalwindsafety.org
43 / 171
Made with FlippingBook flipbook maker