Technical training
Service Lift Training Standard / V4
The aim of this lesson is to enable the participants to test and ensure the functionality of drive and safety wire ropes and racks in accordance with the manuals and inspection lists.
After successfully having completed Lesson 12 of the Service Lift Inspection and Maintenance Module:
71) The participants can take responsibility to do a visual inspection of drive and safety wire ropes according to manuals (Ability, intermediate level)
ELEMENT 12.1 - DRIVE ROPES, IN GENERAL
Learning objective:
72) The participants can perform a visual inspection of the diameter of drive rope and safety rope in unloaded state at three points: bottom, middle and top (Skills, intermediate level)
The instructor shall:
Demonstrate how to inspect drive and safety ropes
Facilitate practical training on inspecting drive and safety ropes
Provide feedback to the participants on their performance during the practical training
The participants shall:
Engage in practice, share experiences, and apply the received feedback in following exercises
ELEMENT 12.2 - TENSION WEIGHTS
Learning objectives:
73) The participants can explain how to do a visual inspection of tension weights installation in accordance with the manuals (Knowledge, intermediate level)
74) The participants can explain how to inspect tension weights to give a distance/space above (full loaded lift) or below (unloaded lift) in accordance with the manuals. (Knowledge, intermediate level)
75) The participants can describe how to do an adjustment to tension weights installations in accordance with the manuals (Knowledge, basic level)
Global Wind Organisation ©2024 / www.globalwindsafety.org
85 / 166
Made with FlippingBook flipbook maker