Technical training
Lift Standard / V3 2023-05-02
9. LIFT COMMISSION, INSPECTION, INSTALLATION AND MAINTENANCE MODULE 9.1 Aims of the Lift Commission, Inspection, Installation and Maintenance Module The aim of this module is: to enable the lift technician to: install, inspect the lift prior to commissioning and perform maintenance; to take correct measures to acquire assistance; and perform simple adjustments or replacement of parts in a WTG lift. Fundamental for the training is the wind technician’s attention to, and awareness of, always following and seeking guidance from the relevant lift manuals and instructions.
The overall learning objective of this module is:
139) The participants can solve routine tasks in relation to the commissioning, inspection, installation, and maintenance of lifts in a WTG following relevant guides and manuals (Ability, basic level).
9.2 Course Participants Prerequisites for the Lift Commission, Inspection, Installation and Maintenance Module GWO Lift User Module training or similar brand specific user training is a prerequisite to participate in the Lift Commission, Inspection, Installation and Maintenance Module training. Basic technical experience and knowledge, primarily mechanical and electrical, is necessary to be able to get full benefit from the training. 9.3 LCIIM Module Instructor’s Qualification As an addition to the GWO Requirements for Training, a competent LCIIM module instructor must be acknowledged as such by a competent instructor or train-the-trainer.
A competent instructor or train-the-trainer must hold the sufficient lift technical experience on multiple lift types obtained by, for example, work experience, lift trainings and manufacturer led lift trainings.
Note
The purpose of this is to ensure the necessary technical understanding of lift functionalities and is as such not lift brand specific.
9.4 Duration of the Lift Commission, Inspection, Installation and Maintenance Module The total contact time for completing the Lift Commission, Inspection, Installation and Maintenance Training Module Training Module is 14 hours and 0 minutes.
The training provider must not exceed the times per day given in table 9.4.1 below.
Maximum Duration Per Day
Global Wind Organisation©2023 / www.globalwindsafety.org
94 / 171
Made with FlippingBook flipbook maker