Carrejo et al. Carbon Neutrality
(2026) 5:3
Page 11 of 35
engineered process that emits CO 2 during paper manu- facturing. Prior research has suggested that while the biogenic carbon captured in biomass is ultimately re- emitted during production or end-of-life decomposition, the temporal dynamics of this carbon cycle can influ- ence its climate impact [1]. This provides the rationale for including a dynamic assessment as system 5. In this analysis, the maximum quantity of CO 2 available for cap- ture is defined by the total carbon content of the biomass processed by the mill. Carbon sequestration estimates were based on the aboveground biomass carbon content, assumed to be 51.6% [7]. All GHG emissions associated with paper production are treated as leakages from the initial biogenic carbon stock [50]. Additionally, the final carbon content of the linerboard product—assumed to be 46.13% [7]—was modeled as fully oxidized to CO 2 upon production [51].
2.3.2 Pulp and paper mill process Figure 3 represents the flow diagram of the reference paper mill. The linerboard production starts once the softwood logs and wood chips are received at the pulp mill gate. They are stored onsite, and the logs are trans- formed into chips of a small size to promote proper impregnation of the chemicals used to delignify the wood. This size change is made in the woodyard sec- tion, where the logs are debarked, cleaned, and chipped. The bark and the rejects from the screeners that con- trol the chip size are subsequently used in the biomass boiler for in-situ steam and power generation. Here, we found a source of biogenic CO 2 emissions. The proper- size chips are fed into the continuous digester through a conveyor, where sodium hydroxide (NaOH) and sodium sulfide (Na 2 S) are used as pulping chemicals to separate the lignin from the cellulosic fibers, and with the use of steam, the temperature and pressure conditions are raised (170 °C, 60 bar). The mixture of chemicals used in this stage is called white liquor for its transparent yellow appearance. In the continuous digester, the chips pass through 5 different zones: first, the impregnation with white liquor under high pressure; second, the heating zone where the pulping temperature is reached to enter into the third zone where the “cooking” process occurs; and then the pulp is washed in the fourth zone, to finally being blown outside of the digestor in the fifth zone. The pulp goes through a screening process and is subsequently sub- jected to a series of washing stages. The freshwater enters the process in the final washing stage and, counter-cur- rently, goes back through the washers to clean the pulp.
2.3 System description 2.3.1 Biomass procurement
The softwood logs used as raw material for the kraft liner paper were assumed to be produced under typical silvi- cultural practices in the southeastern U.S.; the emission factor used for estimating the CO 2 emissions includes the primary forest operations, such as site preparation, planting, applying fertilizers and herbicides, thinning and logging. Additionally, around 20% of the biomass used to produce paper was assumed to enter in the form of wood chips. Another emission factor considering the chipping stage was used for this portion. The life cycle inventory of the cultivation, harvesting, and handling of southern softwood chips is presented in Table S4 [52].
Fig. 3 Flowsheet diagram of pulp and paper mill
Made with FlippingBook Online newsletter maker