PAPERmaking! Vol12 Nr2 2026

Carrejo et al. Carbon Neutrality

(2026) 5:3

Page 12 of 35

Then, the filtrate from the first washer joins the liquor that went out from the digester, where it is finally sent to the evaporators. The liquor in this part is called black liq- uor due to the dissolved lignin after cooking, which pro- vides the black color to the liquid phase. At this stage, the dissolved solids have an average concentration of 16%, and a final concentration of 72% is reached throughout the evaporators and concentrators. With this level of sol- ids, the concentrated black liquor is combusted inside the recovery boiler. The second source of biogenic CO 2 is found here. The organic solids (lignin and a small por- tion of carbohydrates) of the black liquor combust and provide heat to produce steam, leaving the inorganic sodium and sulfur compounds to go to the bottom of the boiler, where they react with carbon (char) and carbon dioxide at high temperatures and under reduced oxygen content, forming a smelt that consists of sodium carbon- ate (Na 2 CO 3 ) and sodium sulfide (Na 2 S). Note that the carbon in the Na 2 CO 3 enters the process with the wood; thus, it is considered biogenic. The smelt is dissolved in water, producing a greenish liquid called green liquor. This liquor is clarified, elimi- nating a small amount of carbonaceous solids called dregs. The clarified green liquor is put in contact with calcium hydroxide (Ca(OH) 2 ) (Eq. 12), previously pro- duced after slaking calcium oxide (CaO) (Eq. 14), precipi- tates calcium carbonate and produces NaOH. Note that the resultant liquor corresponds to the white liquor used in the continuous digestor after separating the CaCO 3 . This CaCO 3 or lime mud is dried and sent to the lime kiln, where heat is provided to proceed with the endo- thermic calcination reaction (Eq. 13).

product. The paper is formed in a fourdrinier machine, where vacuum helps to remove water and form the paper sheet, further drying through the press and dryer sec- tions. Finally, a roll is formed, cut, and prepared to be shipped to the customers. The combined heat and power (CHP) plant in the pulp and paper mill is connected to all the heat energy sources (recovery boiler with a 64% thermal efficiency, biomass boiler with a thermal efficiency of 75%, and natural gas boiler with a thermal efficiency of 78%). The boilers pro- duce superheated steam at 83 bar and 547 °C, which passes through a multistage back-pressure turbine, where medium-pressure steam at 11 bar and 305 °C and low- pressure steam at 4.2 bar and 224 °C are extracted and distributed for utilization in the different areas of the paper mill (digester, evaporators, and paper machine (dryers)), as well in the deaerators and air heaters of the boilers in the CHP system. Electricity is generated and supplied internally when the steam passes through the turbines. Given that our reference mill is 100% electricity self-sufficient, the power excess is assumed to be sent to the grid and offset some CO 2 emissions according to the emission factors regarding the mill’s location. 2.4 Amine-based carbon capture and storage facilities The flue gas containing CO 2 from the paper mill is fed into a capture system using monoethanolamine (MEA) as solvent. The MEA-based CCS consists mainly of two col- umns: the absorber, where the flue gas is in contact coun- tercurrently with the solvent, where the MEA chemically bonds to CO 2 [53]. Then, once the solvent has trapped the CO 2 , it is sent to the stripping column, where this mixture of MEA-CO 2 is heated up to ~ 120 °C to release the CO 2 . The interaction of MEA with CO 2 is repre- sented in Eqs. 15 to 21 [53].

(12)

Na 2 CO 3 + Na 2 S + Ca ( OH ) 2 → CaCO 3 + Na 2 S + 2 NaOH

(13)

CaCO 3 + Heat → CaO + CO 2

(15)

2 H 2 O ↔ H 3 O

+ OH

+

−

(14)

CaO + H 2 O → Ca ( OH ) 2

2 − 3

(16)

HCO −

3 + H 2 O ↔ CO

+ H 3 O

+

We found the third source of biogenic CO 2 emissions in the lime kiln. However, the CO 2 in the flue gas from the lime kiln is a mixture of biogenic and fossil-fuel- derived carbon. 61.4% of the lime kiln CO 2 emissions are biogenic and generated by releasing CO 2 from the CaCO 3 to produce CaO, and 38.6% comes from the natural gas being combusted to provide the heat needed for the cal- cination reaction [7]. On the other hand, the clean fibers are pumped from the pulp plant to the paper machine. In the paper machine, a set of cleaners separates sand or other impuri- ties. Subsequently, the fibers pass through a set of refin- ers to increase the strength of the paper once the sheet is formed, and chemical agents are applied to the fiber furnish to control specific paper properties in the final

(17)

MEA +

+ H 2 O ↔ MEA + H 3 O +

(18)

CO 2 + OH

→ HCO

− 3

−

(19)

HCO − 3

→ CO 2 + OH

−

(20)

MEA + CO 2 + H 2 O → MEACOO −

+ H 3 O

+

(21)

MEACOO −

+ H 3 O

+ → MEA + CO 2 + H 2 O

CO 2 and water leave the upper part of the stripping col- umn, being further separated through a condenser. The dried

Made with FlippingBook Online newsletter maker