PAPERmaking! Vol12 Nr2 2026

Coatings 2026 , 16 , 299

6of 25

Table1. Composition of the barrier dispersion. Dry solid content of the constituent parts, dry mass of the components used during the preparation and coating formulation. The formulation is given as parts (by wt.) per hundred parts of dry bentonite (pph).

Dry Solid Content (%)

DryMass (kg)

Coating Formulation (pph)

Component

Bentonite, aqueous suspension

8.5

26.6

100 252

Bentonite, powder

92.5

3.8

Starch, aqueous solution

26

76.7 15.3

PEG 600 (liquid)

100

50

2.2.2. Pilot Coating The pilot-scale coating trials were conducted using the UMV Coating Systems AB pilot coater in Säffle, Sweden, operating at a machine speed of 400 m min − 1 on paperboard with a web width of ca. 0.55 m. The pilot coater is shown in Figure 1. The coatings were applied onto the brown unbeached backside side of the substrates using a short-dwell-time applicator (SDTA), also referred to as a zero-dwell coater (Invo Coater ® , UMV Coating System AB, Säffle, Sweden). The dwell time between application and metering was 0.005 s at a machine speed of 400 m min − 1 . The coater can be equipped with several different types of metering elements, integrated in the SDTA coating unit. In the thin multilayer coating trials, the metering element was a soft and resilient polymer tip (Invo Tip, UMV Coating System AB, Säffle, Sweden). The coat weight was controlled by the metering tip angle. The metering tip angle was kept constant at 20 ◦ during all thin multiple coating trials. For comparison, thick single-layer and double-layer coatings were performed using volumetric rod metering elements (diameter 14 mm) to achieve the required coat weights. The SDTA coating unit and the metering elements were further described by Christophliemk et al. [47].

Figure1. The pilot coater used in the trials. The figure shows the state of the pilot plant during the present study and does not include modifications made later. The insertion shows an enlargement of the application/metering unit. Figure 1 is based on an image published by Christophliemk et al. [47]. The online drying system comprised the following components: 1. One electric IR dryer (manufactured by Ircon Drying Systems AB, Vänersborg, Swe- den) equipped with 12 individual IR frames, distributed as 6 frames on each side of the web, where the total installed power was 1036 kW, i.e., 86.3 kW per individual IR frame. The total length of the electric IR dryer was 3.6 m. At the maximum power

https://doi.org/10.3390/coatings16030299

Made with FlippingBook Online newsletter maker