PAPERmaking! Vol12 Nr2 2026

Coatings 2026 , 16 , 299

11of 25

Table 4. Bendtsen roughness and number of pinholes for multiple coated paperboards and thick single- and double-coated paperboards. Error limits indicate standard deviation. A minor portion of the pinhole results are derived from the work by Emilsson et al. [46].

Roughness (mLmin − 1 )

Pinholes (Number/dm 2 )

Sample Name

Base paperboard 1119 ± 139 Series A—IR 20%

BASE

>30

A1 A2 A3 A4 A5 A6

883 ± 165 765 ± 141 691 ± 151 676 ± 152 495 ± 64 490 ± 134 881 ± 134 861 ± 135 770 ± 148 687 ± 112 584 ± 156 585 ± 100 496 ± 126

>30

19.0 ± 3.6 4.6 ± 2.0 1.6 ± 1.2 0.0 ± 0.0 0.0 ± 0.0

Modified Series A—IR 80%

MA2 MA3 1

>30

Not measured

Not measured

Series B—IR 40%

B1 B2 B3 B4 B5 B6

>30 >30 >30 >30 >30

9.4 ± 3.4 Modified Series B—IR 40%—half of the IR frames are active MB6 482 ± 82 0.0 ± 0.0 Reference thick single coating RSA1 527 ± 89 >30 RSB1 689 ± 135 >30 Reference thick double coating RDA1 526 ± 51 >30 RDA2 662 ± 129 >30 RDB1 474 ± 93 >30 RDB2 431 ± 90 >30

1 —Sample MA3 was excluded from the test protocol due to severe blistering.

MB6 exhibited a much lower pinhole density than M6. During the MB6 run, all IR frames located on the uncoated side of the web were switched off, reducing the total IR power from 40% to 20%. However, the IR frames positioned on the coated side remained active at 40% of their maximum power. All thick reference samples possessed a higher number of pinholes than the detection limit of 30 pinholes/dm 2 . Although their coat weights were higher than those of the multilayer samples, none of the reference coatings showed fewer pinholes than samples A2 to A6 in Series A or the samples B6 and MB6. Notably, sample A2 contained fewer pinholes than RDB2, despite RDB2 having almost three times the coat weight. This probably relates to the dynamics of drying thick layers at high machine speeds. Higher IR power is needed to transfer sufficient energy to the substrate/sedimentation layer at increasing coat weight. As expected, all coated samples exhibited lower Bendtsen roughness than the uncoated substrate. A clear trend was observed in which the Bendsen roughness of the multilayered samples decreased with increasing number of layers, although the reduction from one layer to the next was not always significant. An increase in IR power when drying the thin multilayered samples did not result in any significant changes in Bendsen roughness (see Series A and Series B).

https://doi.org/10.3390/coatings16030299

Made with FlippingBook Online newsletter maker