Coatings 2026 , 16 , 299
16of 25
Figures 3–5 illustrate the dynamics of oxygen permeation. Only small differences were observed among the four samples in Series A containing three to six layers (Figure 3), in con- trast to the clear reduction in pinhole density. This demonstrates that oxygen ingress cannot be explained solely based on pinhole numbers. The experimental error in Figures 3–5 can be estimated from the error limits for the AOIR values in Table 7. Figure 4 reveals that the rate of oxygen increase observed in the reference samples was substantially higher compared to any of the multilayered samples in Series A with more than one coating layer. Figure 5 further demonstrates that deactivating all IR frames on the uncoated side significantly reduced the rate of oxygen concentration increase, indicating enhanced barrier performance under these modified drying conditions.
ȱ Figure 3. Oxygen concentration vs. time for BASE and Series A. Mean values of two repeated measurements. Lines are included in order to increase the visibility.
ȱ Figure 4. Oxygen concentration vs. time for BASE and reference samples RSB1, RSB1 and RSB2. Mean values of two repeated measurements. Lines are included in order to increase the visibility.
https://doi.org/10.3390/coatings16030299
Made with FlippingBook Online newsletter maker