Coatings 2026 , 16 , 299
18of 25
those prepared with a single thick layer. This is likely attributable to the substantial volume of aqueous dispersion applied during the pass through the coater for the reference samples RSA1 and RSB1. The increased wet coating volume may lead to more blistering, pinholes and increased water penetration into the base paperboard. A detailed examination of the double-coated reference samples (Table 4) revealed surprisingly high Bendtsen roughness values for RDA1 and RDA2 compared to RDB1 and RDB2. This observation may be attributed to insufficient IR power during the drying of RDA1 and RDA2, which likely resulted in inadequate heating of the substrate beneath the coating layer. Such conditions are expected to promote water penetration and subsequent swelling. The variations in Bendtsen roughness among repeated measurements of the same sample, reflected by the error limits in Table 4, are indicative of inherent heterogeneity in the surface structure of the uncoated paperboard. 4.2. Adhesion and Crystallinity Modified starches are used by the paper industry in high-speed surface sizing applications to increase the surface strength of the paper and to improve properties such as internal bond, tensile strength, and folding ability. Unmodified and modified starches are also used as an adhesive in high-speed paper coating applications to bind clay particles together and to the paper [24]. Based on pencil hardness tests and SEM cross- sectional images, Santos et al. [62] concluded that starch–bentonite coatings possessed strong bonding to the base paper. Thus, the coatings in the present study likely possessed strong adhesion to the base paperboard. The present study showed a distinct negative correlation between pinhole formation and barrier properties. Although the number of pinholes seemed decisive, it cannot be excluded that starch crystallinity had a minor effect on the barrier properties observed in coated samples without pinholes. Both pure starch and thermoplastic starch are semi- crystalline polymers. Amorphous polymers exhibit, in general, higher oxygen permeability than their semicrystalline counterparts, at least at conditions that are not too humid [85,86]. The crystallinity of starch—and therefore the barrier performance of starch-based coatings— can be affected by several factors, including the ratio of amylopectin to amylose, the type and concentration of plasticiser, and process conditions like drying rate, temperature, and relative humidity during film formation [87,88]. However, the relationship between crys- tallinity and oxygen barrier properties, as well as crystallinity and mechanical properties, is likely more intricate than simply depending on the degree of crystallinity. Guinault et al. [89] showed that both the degree of crystallinity and the crystalline morphology must be taken into consideration when describing the effects of crystallisation. In addition, it has been proposed that bentonite promotes crystallinity in starch films [64]. Analyses of microstructure and crystallinity were beyond the scope of the present study and are recommended for future research. 4.3. Effects of Coating and Drying Conditions on Oxygen Barrier Properties The origin of pinholes and analogous defects that adversely affect barrier properties can be attributed to several mechanisms. First, the applied coating must achieve thorough coverage of the pores located between the cellulose fibres at the substrate surface. In most cases, this necessitates the formation of a uniform coating layer. Inadequate coating uniformity will result in residual open pores. Additionally, the emergence of pinholes may be induced by entrapment of air bubbles within the coating dispersion [71] or from blistering phenomena [49]. Multilayers are anticipated to reduce pinhole pathways by covering holes present in previous layers, which results in decreased gas transport through the pinholes [71]. Notably, Table 4 demonstrates that sample A2 (comprising two thin layers
https://doi.org/10.3390/coatings16030299
Made with FlippingBook Online newsletter maker