6
J Renew Mater. 2025
3 Results and Discussion 3.1 Characterization of EPW Mycelium Biocomposites
Moisture is a critical parameter for the successful development of fungal mycelium, as it directly influences the organism’s physiological processes. In the present study, the moisture content of the finalized EPW biocomposites ranged from 56% to 58%, which falls within the optimal range for fungal growth. Decay fungi typically thrive at moisture levels between 40% and 80% [40]. In addition to moisture, the substrate composition plays a pivotal role in the development of mycelium-based composites. The choice of substrate not only supports mycelial growth but also markedly impacts the properties of the produced biocomposite. Depending on the substrate used, the content of polysaccharides, proteins, lipids, and chitin in mycelium may vary, thereby impacting the morphology, density, and functional properties of the resulting biocomposite. The raw substrates used in EPW biocomposites exhibited distinct particle size distributions (Fig. 2). EPW, present in all formulations, contained 60% coarse particles ( ≥ 10 mm). Birch sawdust had the highest proportion of fine particles ( < 3 mm), comprising 70% of its mass, whereas hemp shives were richer in medium-sized particles ( ≥ 3 mm), accounting for 37%. These differences are likely to influence the microstructure and properties of the composites.
Figure 2: Particle size distribution of raw materials used in biocomposites. EPW: egg packaging waste substrate; HS: hemp shive co-substrate; BS: birch sawdust co-substrate Lignocellulose, a key structural component of wood and non-wood fibers, represents a major renewable resource. The white rot fungus Trametes versicolor degrades cellulose, hemicelluloses, and lignin simultane- ously at relatively uniform rates [41]. Among the combinations (Table 1), EPW1, comprising egg packaging waste and wheat bran, proved effective for composite development. EPW, derived from recycled paper, contains approximately 35% cellulose, 19% lignin, 21% ash, 20% hemicelluloses, and 4.5% extractives [42]. Its high ash content is attributed to non-fibrous impurities such as fillers, pigments, ink residues, and synthetic binders. Nevertheless, these impurities, including wet-strength resins, did not inhibit fungal colonization. EPW2 biocomposites, incorporating 50% hemp shives, demonstrated effective fungal colonization. Hemp shives are composed of approximately 50% cellulose, 20% hemicelluloses, and 10% lignin [43]. EPW3 composites incorporated 50% birch sawdust as a co-substrate, which contains approximately 43% cellulose, 25% hemicelluloses, and 23% lignin [44]. Substrate moisture, particle size, and chemical composition collectively contributed to favorable fungal growth and successful biocomposite formation, as examined in the following sections.
Made with FlippingBook Online newsletter maker