PAPERmaking! Vol12 Nr2 2026

8

J Renew Mater. 2025

3.2.3 Flexural Strength The highest flexural strength and modulus of elasticity were observed in EPW1 biocomposites, reaching 0.95 and 26 MPa, respectively ( p < 0.05) (Table 2). EPW3 exhibited significantly higher flexural strength (0.89 MPa) than EPW2 (0.63 MPa). Both co-substrates containing composites (EPW2 and EPW3) showed similar flexural moduli (~18 MPa), which were significantly lower than that of EPW1. Flexural properties positively correlated with density, as the denser EPW1 composite also demonstrated superior mechanical performance. Similar trends were reported by Appels et al. [49], where MB with higher density (beech sawdust) had higher flexural strength (0.26 MPa) and modulus (9 MPa), compared to lower-density rapeseed straw-based composites (0.22, 3 MPa). In contrast, Teeraphantuvat et al. [46] found that adding 40% paper waste reduced flexural strength in corn husk and sawdust biocomposites. This and previous studies [50,51] emphasize that the mechanical performance of mycelium-based materials is influenced by multiple factors, including fungal species, substrate type, growth conditions, and compaction. Therefore, direct comparisons across studies should be approached with caution, and results interpreted within the context of specific experimental setups. 3.3 Thermal Conductivity Average thermal conductivity ( λ ) values ranged from 43 to 51 mW ⋅ m − 1 ⋅ K − 1 , with the lowest observed in the hemp-containing EPW2 composite (Fig. 3A). Composition of biocomposites significantly affected thermal conductivity ( p = 0.024), with λ for EPW2 significantly lower than EPW1 ( p = 0.029) and marginally lower than EPW3 ( p = 0.052). The addition of hemp shives or birch sawdust influenced the thermal conductivity of the biocomposites due to differences in microstructure and particle size of these co- substrates. Hemp shives contain a relatively high proportion of hollow-core structures, which increase porosity and contribute to lower thermal conductivity by limiting heat transfer. In contrast, birch sawdust exhibits a denser and more compact microstructure, with approximately twice the bulk density (~200 kg/m 3 ) of hemp. Moreover, a finer sawdust particle size may enhance the number of contact points within the matrix, thereby increasing thermal conductivity.

Figure 3: Thermal conductivity ( A ) and its correlation with density ( B ) of EPW mycelium biocomposites. EPW: egg packaging waste; Compositions 1–3 correspond to different substrate formulations. Different letters (a–b) indicate statistically significant differences between composites ( p = 0.029)

Made with FlippingBook Online newsletter maker