2023-05-02_LIFT_V3

Technical training

Lift Standard / V3 2023-05-02

ANNEX 4 - VERSION HISTORY

Amendment date

Version

Approved by & date

Description of changes

Changes throughout

New layout

MAC deleted throughout the standard.

Section 2 Terms and Conditions

• New text added- As low as reasonably practicable: This means that a risk is identified and controlled to a lower level weighted against the effort, time and money needed to control it. Section 4 Scope • Text replaced to- Global Wind Organisation is a non-profit body founded by the wind turbine manufacturers and owners. Our members strive for an injury free work environment in the wind turbine industry, setting common international standards for safety training and emergency procedures. • This standard describes the requirements for lift training courses that are recommended by the members of GWO. This standard comprises of three modules: 1) Lift User Module 2) Lift Commission and Inspection Module 3) Lift Commission, Inspection, Installation and Maintenance Module • The members of the Global Wind Organisation (GWO) recognise trained persons as competent within use, inspection, installation, and maintenance of lifts in the wind industry and accept the trained person as possessing the required abilities to use, commission, inspect, install, maintain, and evacuate a lift where they as duty-holders are accountable for safety. • This standard has been developed in response to the demand for recognisable lift training in the industry and has been prepared in co-operation between the members of GWO based on risk assessments and factual incident and accident statistics from G+ and the wind industry. Disputes and potential non-conformities should be brought to the attention of the GWO Audit and Compliance Committee. Section 5.1 Overview • The template provides a table for split modules; the original content does not mention a split module. The original content is adopted. Section 5.4 Duration • Text replaced to: The total contact time for completing the Basic Safety Training Standard is 25 hours and 0 minutes. This is based on the times given in the module timetables and summarised in table 5-4.1 below.

Global Wind Organisation©2023 / www.globalwindsafety.org

168 / 171

Made with FlippingBook flipbook maker